Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-12-2004, 03:37 PM
|
#1 |
|
Registered Member
Join Date: Sep 1998
Location: IL
Posts: 1,155
|
Vise grips
 Just use the jamb-nut technique with two nuts. The studs should only be threaded finger tight in the block anyway. So all you're really fighting against is the thread sealer you used on the lower studs.
__________________
Craig Supercharged 93 GT "I drive way too fast to worry about cholesterol!" Then I went to the doctor.... whoa 312! Hello Lipitor |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head studs, Any one here using them? | 93 Cobra needs input | Windsor Power | 9 | 01-23-2003 10:36 PM |
| Head Studs | speedytang | Windsor Power | 3 | 09-17-2002 11:30 AM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| ARP Head Stud install | Prochrgd1 | Windsor Power | 7 | 03-27-2002 01:31 AM |